July 27, 2016

TFV8 Baby Tank : How to Build RBA Guide

Smok TFV8 Baby Tank,as we have known,is the micro version of TFV8,is the smok micro tfv8 tank and has 3mL eJuice capcity and adopts two new Turbo engines : Micro V8-D Quad Core and Micro V8-S Dual Core to provide beast cloud. Now TFV8 Baby first batch has arrived at vapingbuy.com and you can buy smok tfv8 baby tank right here now.

TFV8 Baby Sub ohm Tank based on TFV8 and it supports RBA function at the same time and following is a detailed Smok TFV8 Baby guid on how to build the RBA

Step 1 : Assure your hand is clean before taking RBA deck apart .

Micro TFV8 Guide

Step 2 : Installing and positioning the pre-wrapped coil ,then cut the ends of wire off.

Smok Micro TFV8 Guide

Note : Pls Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.

Step 3 : Cutting a strip of cotton to a reasonable size and insert the cotton, and placing it in the middle, after that,pls cut the cotton at an angle and make sure it’s not too short and not too long.

Micro TFV8 RBA Guide

Step 4 : Wet the coil with your e-liquid and adjust the cotton.

Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically toensure the resistance remains the same.

Step5 : Now you can enjoy your DIY fun.

Leave a Reply

Your email address will not be published. Required fields are marked *